How to install

Installation Instructions for Freedom Headliners

**Warning**

- **Adhesive Application Temperature:** Ensure adhesive is applied in temperatures between **70°F and 100°F**.

- **Pre-application Temperature:** Do not apply if the vehicle will encounter temperatures below 32°F within 72 hours of application.

Preparation:

1. **Climate Control:** It is recommended to perform this procedure in a climate-controlled area.

2. **Temperature Check:** Ensure the Freedom Headliner surface is between **70°F and 100°F** for optimal Velcro strip adhesion.

Materials Needed

- Freedom Panels (remove from vehicle)

- Rubbing alcohol for cleaning surface

- Clean paper towel

- Non-scratch surface (e.g., a table with a towel)

Installation Steps

1. **Panel Preparation:**

- Carefully remove the Freedom Panels and place them on a non-scratch surface such as a table covered with a towel.

- Ensure the Freedom Panels are free of dust and residues for optimal adhesion.

- Rubbing alcohol works well

2. **Velcro Strip Preparation:**

- On the back of your new headliners, locate the Velcro strips.

- With the Velcro still attached to the headliners, **peel off the plastic backing** of the Velcro strips. **Avoid touching the sticky adhesive** during this process.

3. **Aligning and Pressing:**

- Align the headliner in the basin of the Freedom Panel.

- Firmly press the panel onto the Freedom Panel.

- Using your hands, apply consistent pressure on the areas where the Velcro strips are located to ensure proper adhesion.

4. **Curing Time:**

- Allow at least **2 hours** before returning the Freedom Panels to your Jeep. For optimal results, a curing time of **24 hours** is recommended.

- Once applied, **do not remove the headliners for at least 72 hours** to ensure proper adhesion.

Final Notes

Following these instructions will help ensure the best results for your Freedom Headliner installation. Enjoy your newly enhanced Jeep interior!